NiteRider PRO 1400 RACE User Manual

PRO 1400 RACE
USER GUIDE
USE THE LIGHT THAT PROS USE
NiteRider™ provides mountain and road bike riders the most
durable, reliable and best performing lights in the market.
It's not a statement we make lightly, as the backbone of our
success has been built on providing lights of exceptional
quality to this very demanding market sector. Through 22 years
of actively supporting professional riders at 12 and 24 hour
endurance events we have learned what it takes to become the
stand alone leader in mountain bike lighting.
To get the most from your NiteRider™ light, we urge you to
familiarize yourself with the following safety and operating
instructions.
PARTS LIST AND IDENTIFICATION
Please verify the contents of your Pro 1400 Race system:
A. Pro 1400 Race Headlamp
B. Li-Ion Race Battery
C. Universal Handlebar Mount (UHM)
D. Helmet Mount
E. 36" Extension Cable
F. A/C Adapter
D.
F.
MOUNTING THE HEADLAMP
The Pro Series headlamp can be mounted to the handlebar
or a helmet.
Universal Handlebar Mount
The Universal Handlebar Mount (UHM) is designed to fit on
virtually any handlebar. Included with the mount is a 2.5 mm
Allen wrench for adjusting the mount.
MOUNTING THE HEADLAMP CONT.
1. Turn the knob counter-clockwise,
allowing the hinge to swing open.
2. Place the UHM on the handlebar on
the left side the stem, orienting the
rectangular notch in the slider clip
to the rear.
3. Swing the hinge down to make
contact with the handlebar.
4. Swing the bolt up, seating the knob
into its recess.
5. Turn the knob clockwise to tighten and secure the mount
to the handlebar.
The UHM can be adjusted to accommodate any handlebar angle.
By loosening the 2.5 x 30 mm Allen screw, you can move the swing
arm back and forth to straighten the headlamp. Tighten the 2.5 x 30
mm screw after the adjustment.
To pivot the headlamp, loosen the 2.5 x 12mm screw located under
the slider clip and swing arm and rotate the headlamp to the desired
position. Make this adjustment before tightening the 2.5 x 30 mm
screw.
Helmet Mount
1. Unclamp the straps on each side of the helmet mount
and pull them free.
2. Position the plastic mounting plate as close to the centerline of the
helmet as possible, orienting the parallel grooves on the slider clip
to the rear.
3. Feed each strap into and out of two helmet vents, circling each strap
back to the upper edge of the corresponding clamp.
4. Fasten the straps by inserting them into the clamps and snap shut.
E.
Inserting the Headlamp into the Handlebar or Helmet Mount
Insert the headlamp into the handlebar or helmet mount slider clip
from the rear forward. Gently rocking the lamp as you slide it may
help. Do not push the release lever when inserting the headlamp
into the slider clip; let the lamp snap into place by itself.
Note: After mounting the headlamp, adjust it so the
beam illuminates the road properly without distracting oncoming riders.
To remove the headlamp, push the release lever
forward and slide the lamp backward.
Release Lever