NiteRider PRO 2800 ENDURO REMOTE User Manual

Now with Remote Switch
PRO 2800 ENDURO REMOTE
PRO 3600 ENDURO REMOTE
USER GUIDE
USE THE LIGHT THAT PROS USE
NiteRider™ provides mountain bike riders the most durable, reliable
and best performing lights in the market. It's not a statement we make
lightly, as the backbone of our success has been built on providing
lights of exceptional quality to this very demanding market sector.
Through 22 years of actively supporting professional riders at 12 and
24 hour endurance events we have learned what it takes to become
the stand alone leader in mountain bike lighting.
PARTS LIST AND IDENTIFICATION
Please verify the contents of your Pro 2800 / 3600 Enduro system:
A. Pro 2800 / 3600 Enduro Headlamp
B. Remote Switch
C. Li-Ion Enduro Battery
D. Universal Handlebar Mount (UHM)
E. 36" Extension Cable
F. AC Adapter
Handlebars not included
D.
E.
MOUNTING THE HEADLAMP
The Pro 2800 / 3600 Enduro headlamp can be mounted to the
handlebar or a helmet.
Universal Handlebar Mount
The Universal Handlebar Mount (UHM) is designed to fit on virtually
any handlebar. Included with the mount is a 2.5 mm Allen wrench
for adjusting the mount.
1. Turn the knob counter-clockwise, allowing the hinge to swing open.
2. Place the UHM on the handlebar on the left side of the stem,
orienting the rectangular notch in the slider clip to the rear.
3. Swing the hinge down to make contact with the handlebar.
A.
4. Swing the bolt up, seating the knob into its recess.
5. Turn the knob clockwise to tighten and secure the mount
to the handlebar.
The UHM can be adjusted to accommodate any handlebar angle.
By loosening the 2.5 x 30 mm Allen screw, you can move the
swing arm back and forth to straighten the headlamp.
Tighten the 2.5 x 30 mm screw after the adjustment. To pivot the
B.
headlamp, loosen the 2.5 x 12 mm screw located under the slider
clip and swing arm and rotate the headlamp to the desired position.
Make this adjustment before tightening the 2.5 x 30 mm screw.
Inserting the Headlamp into the Handlebar
Insert the headlamp into the handlebar or helmet mount slider clip
from the rear moving forward. Gently rocking the lamp as you slide it
may help. Do not push the release lever when inserting the headlamp
into the slider clip; let the lamp snap into place by itself.
To remove the headlamp, push the release lever forward and slide the
lamp backward.
C.
Note: After mounting the headlamp, adjust it so the beam illuminates the roady without
distracting oncoming riders.
F.
CLICK!