Advertisement
Remove the protection covers on the wheel. Loosen and take off the washers and nuts
on wheel, then put the wheel into the fork. Install the washer and nut to fix one side of the
wheel, tighten the nut using the appropriate wrench. Do the same installation on the other
side. Please make sure the washer hook insert into the hole on the fork.
IMPORTANT: CHECK THE TIGHTENING OF THE NUTS ALL THE TIME!
Step 2. Assemble the bracket
Remove the protection covers on the bracket. Make sure the brake lever is located at the
left hand. Insert the stem pillar into the fork tube to the minimum insertion line, which is
indicated on the stem pillar. Face the handlebar stem forward directly in line with the front
wheel. Make sure the bracket is centred.
Move upward the handlebar, adjust to your desired angle, then tighten the four bolts and
nuts using the appropriate wrench.
Tighten the upper stem pillar bolt using the appropriate wrench. Then tighten the head
cup top using the appropriate wrench.
Check handlebar for tightness. If you can move it forward or backward, the clamp bolts
are not tight enough.
Check steering by straddling the front wheel and trying to turn the handlebar. If you can
turn the handlebar without turning the front wheel, the stem is too loose. Line up
handlebar with front wheel. Re-tighten the stem pillar bolts as instructed.
3
Advertisement
