Advertisement
IMPORTANT: ALWAYS MAKE SURE ALL NUTS AND BOLTS ARE FIRMLY
TIGHTENED BEFORE USING THE SCOOTER.
WARNING: THE HANDLEBAR STEM PILLAR MUST BE INSERTED INTO THE HEAD
TUBE UNTIL THE MINIMUM INSERTION LINE INDICATED ON THE STEM IS
COVERED. THE ASSEMBLER IS CAUTIONED AGAINST THE DANGER OF
DAMAGING THE HANDLEBAR STEM PILLAR ASSEMBLY AND POSSIBLE INJURY
TO RIDER IN OVERTIGHTENING THE STEM PILLAR BOLT.
Step 3. Adjust the brake lever if you need.
Using the allen key to loosen the lower screw on the brake lever, adjust the lever to your
desired angle and then tighten the screw.
IMPORTANT: ALWAYS CHECK THE BRAKE FUNCTION BEFORE USING THE
SCOOTER.
Step 4. Adjust the brake function if you need.
Using the appropriate wrench to loosen or tighten the screw on the rear brake. It controls
the tightness of the brake cable. Adjust to your desired tightness but make sure the brake
function will not be effected.
Regularly check the brake rubber is touching the rim to stop, not the tyre. Once find the
rubber in displacement, loosen the screw using the appropriate wrench to adjust the
rubber, make sure the rubber touch the rim to stop. Check the two sides rubber all the
time.
4
Advertisement
