Advertisement
WARNING: If after brake adjustments are made, and the hand brake still does not
function, then have brake repaired or adjusted at a bicycle service shop.
Do not ride if brakes do not function properly.
Use
- Hold both handgrips firmly. Put one foot towards the front of the deck, push off the
ground to propel the scooter forward with other foot. Both feet can fit on the deck when
desired speed has been reached.
- Practice foot positioning at slower speed until you build skill and experience. Shifting
your foot position, or lifting or placing your feet while travelling affects the stability of the
scooter. You have to learn to maintain control while you move your feet on and off the
deck of the scooter.
- Brake lever is located on the left handlebar and used to brake rear wheel. Brake
gradually. Mechanism to reduce speed will get hot from continuous use, do not touch
after braking.
- Shoes are mandatory and we strongly advise you to wear long pants and long sleeve
shirts to avoid injury if you fall. Do not ride barefoot or with loose fitting shoes, thongs or
sandals.
Care Instructions
A. Wheels: Regularly check that the tyre pressure is at the level recommended by the
manufacturer (indicated on the side of the tyre). Make sure the tyres do not show signs of
cuts or abrasion on the sides caused by brake friction. In the interest of safety, both
wheels should be checked regularly and changed if necessary.
To look after the wheel axles, systematically check that the wheels turn properly by
turning the scooter upside-down and using your hand to spin the wheels. If the wheels do
not spin they must then be removed to check their condition. If they are chipped or
dented, new ones should be bought. If there is no visible damage, please contact a
specialist dealer for this.
B. Brakes: Regularly check that the brake is still functional before your riding. If not,
please adjust the brake as our instructions. Please stop using the scooter if the brake do
not function properly after the adjustment. Regularly check the components of brake,
make sure they all tightened before use. Not allowed to disassemble the brake by
yourself.
C. Modifications: The original product must by no means be modified except for the
maintenance-related changes mentioned in these instructions.
D. Nuts and axles and other self-locking fixings: These should be checked regularly.
They can become loose after a while in which case they should be tightened. They can
become worn and not tightened properly, in which case they should be replaced.
MADE IN CHINA
FOR AU / NZ: IMPORTED FOR KMART
STORES IN AUSTRALIA AND NEW ZEALAND.
5
Advertisement
