KVM-TEC smartEasy Quick Instructions

kvm-tec

First Aid

smartEASY
No Power USB is not
(No LED) working
Are the USB
Check the
Devices plugged
powerplug
in correctly?
Is the USB cable
Is the power
on the Local side
supply ok? Try
plugged into the
another Unit.
Are the USB
Devices working
Contact kvm-tec
directly on the
support
Replace the USB
cable from PC to
the Local
Extender
Check if local
and remote Unit
have the same
fi rmware
Check if the local
or the remote
Unit is causing
the problem by
swaping fi rst the
local and than the
remote Unit to
another Unit
Contact kvm-tec
support
Misprints, errors and technical changes reserved
No Video Video error
(stripes in the
Check if all Check if all
cables are plug-
cables are plug-
ged in correctly
ged in correctly
Check if the PC is
Check if the PC is
sending a Image
sending a Image by
by plugging in a
plugging in a
PC? monitor on the
monitor on the
local out of the
local out of the
local Unit
Check if the DDC
PC?
Check if the DDC is is set correctly (in
set correctly (in menu
the menu under
under point „O")
Check if local and re-
Check if both
mote Unit have the
Units have the
correct fi rmware correct fi rmware
Check if the
Contact kvm-tec
network switch
support
is setup correctly
and has enough
bandwidth
Check if other units
have the same
Contact kvm-tec
We are here for you to answer
your questions about installation?
Manual download www.kvm-tec.com
or
kvm-tec Installationchannel on our homepage
personally +43 2253 81912
Check out
our Installation Channel:
picture)
Tune in the easy KVM World Tune in the easy KVM World Tune in the easy KVM World
smartEasy
local Unit
Dual in copper
Art Nr: KT - 8121
point „o")
www.kvm-tec.com
Quick
Instructions
behaviour
V102022
support
smart
Easy
FULL HD - KVM EXTENDER OVER IP FULL HD - KVM EXTENDER OVER IP
•