Insignia NS-DWRF2SS3 User Manual page 17

PROBLEM POSSIBLE CAUSE
The dishes are not The water pressure is too low.
clean enough
The inlet water temperature is too low.
The water temperature may be too low at
the start of the wash cycle.
Dishes are too close together.
Improper use of detergent.
The selected cycle is not suitable for the
soil level on the dishes.
The spray arms are blocked.
The dishes are not dry The rinse aid dispenser is empty or the
enough setting is too low.
Dishes are loaded improperly.
The cycle you chose did not include
drying.
Spots and filming on Water hardness is too high
dishes
Dishes are loaded improperly.
Old or damp rinse aid powder is used.
The rinse aid dispenser is empty or the
setting is too low.
Etching Too much detergent being used.
The inlet water temperature exceeds 150°
F (65.6° C).
Detergent left in Detergent may be too old.
dispenser cup
The spray arm is blocked.
The detergent Improper operation of the detergent
dispenser will not close cover.
Water remains in the The previous cycle has not finished or has
dishwasher. been interrupted.
The dishwasher does The drain is clogged.
not drain properly.
The drain hose is kinked.
The garbage disposal inlet port is
plugged.
Suds in the tub Used the wrong type of detergent.
The rinse aid cup is overfilled.
POSSIBLE SOLUTION
Make sure that the water pressure is above 20 psi.
Use your dishwasher when water demand is low.
Make sure that the dishwasher is connected to a hot
water supply. If not, change the water supply to a hot
water source.
Use your dishwasher when hot water demand is low.
Run the hot water in the sink for 30 seconds or until
the water runs hot, then start the dishwasher.
Reload the dishwasher as shown in Preparing and
loading dishes on page 7.
Add detergent depending on the water hardness
and washing cycle you choose. Use fresh detergent.
Choose a different cycle with a longer washing time.
Make sure that the spray arms are not blocked and
are free to rotate.
Fill the rinse aid dispenser.
Increase the rinse aid setting.
Reload the dishwasher as shown in Loading the
upper rack on page 8 and Loading the bottom rack
on page 9.
Choose a cycle with drying.
For extremely hard water, install a water softener.
Reload the dishwasher as shown in Loading the
upper rack on page 8 and Loading the bottom rack
on page 9.
Use fresh, liquid rinse aid.
Fill the rinse aid dispenser.
Increase the rinse aid setting.
Use less detergent if you have soft water.
Lower the inlet water temperature.
Use fresh detergent.
When you load the dishes, make sure that the spray
arms are not blocked.
Add detergent and rinse aid only as indicated in this
manual. See Filling the detergent dispenser on page
10.
Make sure that the current cycle is finished.
Check the air gap (if so equipped).
Make sure that the disposer is empty (if so
connected).
Make sure that the drain hose is not kinked and is
properly connected.
Check the inlet port to the disposal unit to make sure
that it is not plugged. If a new disposal unit was
installed, make sure its plastic inlet port is open.
Make sure that you use only detergents approved for
automatic dishwashers.
Add rinse aid only to the indicated fill level.
www.insigniaproducts.com
Front Control Dishwasher
17