Troubleshooting; Error Codes - Insignia NS-DWRF2SS3 User Manual

Troubleshooting

Refer to this table to correct minor issues before calling for service.

Error codes

CODE MEANING
Rinse light flashes Either the water
and dishwasher flow is insufficient,
beeps for 15 or the water
seconds* pressure from the
incoming line is too
high
Heavy light flashes Overflow or leak
and dishwasher sensor activated
beeps for 15
seconds
Normal, Heavy, Communication
and Rinse lights exception or issue
flash and
dishwasher beeps
for 15 seconds
* This error results from not enough water flow to the dishwasher. The dishwasher will beep for 1-3 minutes prior to
displaying the error code.
Note: After resolving an error code issue, cycle the power on the dishwasher using the power button on the dishwasher control panel.
If the error code persists, you may need to cycle the power to the dishwasher by resetting the circuit breaker that powers the
dishwasher.
Important:
• If an overflow occurs, turn off the main water supply before calling for service.
• If there is water in the base pan because of an overfill or small leak, the water should be removed before restarting the dishwasher.
PROBLEM
The dishwasher won't
start
The dishwasher beeps
eight times at the end
of the cycle
The rinse aid light is on The rinse aid level is low.
The dishwasher runs
too long
16
POSSIBLE CAUSE
• Faucet is not opened
• Water pressure is too low
• The drain hose is plugged.
• Other (parts failure of inlet or
drain system).
• A leak
• Too much water in the tub
The display board can't receive or
the main board can't send a signal
for over 20 seconds
POSSIBLE CAUSE
The door may not be closed properly.
The power is off or not connected.
The delay start option is selected.
The child lock is activated.
The wall switch is not turned on.
This is normal and indicates that the wash
cycle is complete.
The dishwasher is connected to a cold
water supply.
The cycle time varies, depending on the
soil level of the dishes.
Some cycles and options take longer.
www.insigniaproducts.com
POSSIBLE SOLUTION
• Make sure that the water is turned on
to the dishwasher.
• Make sure that the water pressure is
20~100 psi.
• Check the drain hose.
• Contact Customer Service.
Turn off water to the dishwasher, then
check the filter system for blockage.
Unblock if necessary.
If there is no water in the tub, contact
Customer Service
Contact Customer Service.
POSSIBLE SOLUTION
Make sure that the door is closed and latched.
Make sure that the power is connected and turned
on. If your home has a wall switch above the
dishwasher that powers the dishwasher outlet, make
sure that the wall switch is in the On position.
Refer to the "11- Delay" section on page 7.
Deactivate the child lock. Refer to the "Child lock"
section under Cycles on page 6.
Some dishwashers have a wall switch mounted
above the counter that controls the dishwasher.
Make sure that this switch is turned on.
Add rinse aid.
Make sure that the dishwasher is connected to a hot
water supply. If not, change the water supply to a hot
water source.
When heavy soil is detected, the wash times will be
longer.
This is normal.