Setting The Board Switch Positions - Panasonic DVCPRO AJ-BS901P Operating Instructions Manual

Switches

Setting the board switch positions

1
2
5
Switches 1 and 2 are used to connect the intercom system
using the COMMUNICATION connector (see page 7). For
details on the settings, refer to the intercom system selection
table below.
1
2-lines / RTS / 4-lines
selector switch (SW1)
Intercom system selection table
Intercom system
2W (two-wire system)
4W (four-wire system)
RTS system
Note 1: When the unit is not going to be connected to the intercom
system, set SW1 to ON and SW2 to 4W. (These are the factory
settings.)
Note 2: When there is absolutely no RTS load in the entire intercom
system, set SW1 to ON and use the RTS load function inside the
unit.
2
ENG RTS LOAD ON/OFF
switch (SW3)
3
R tally selector switch (SW200)
Refer to the diagram at right and
select the desired switch position.
6 7 3 4
2W
RTS
4W
SW1 SW2
ON 2W
ON (Note 1) 4W (Note 1)
OFF (Note 2) RTS
ON OFF
MAKE POWER
BS AUDIO board
4
G tally selector switch (SW201)
Refer to the diagram at right and
select the desired switch position.
5
PGM1 selector switch (SW202)
Refer to the diagram at right and
select the desired switch position.
6
MIC1 selector switch (SW203)
Refer to the diagram at right and
select the desired switch position.
7
MIC2 selector switch (SW204)
Refer to the diagram at right and
select the desired switch position.
<Note>
The diagrams show the factory settings.
MAKE POWER
–20dB 0dB
0dB –20dB
0dB –20dB
21