Advertisement
Dimensions
Dimensions
Installation Instructions
Special Conditions
of Use
WARNING:
Always de-energize power before accessing an electrical enclosure
„
Always follow safety and lockout/tagout procedures when working on or near electrical systems and equipment
„
Do not use this product outside of the specified performance and environmental limits
„
Always comply with local installation codes and standards
„
The data from the network module does not carry a functional safety rating . It should be used for monitoring only . If integrating
„
with a safety-rated system, use the SIL 3 outputs on the AVT isolation module instead of the network module outputs .
STEP 1: INSTALL NETWORK MODULE INTO ENCLOSURE
Mount network module flat in enclosure (see *NOTE in dimensional diagram above), or
„
Snap the network module onto the DIN rail, or
„
Mount the network module to the 2 .0 AVT isolation module . See image to the right .
„
STEP 2: CONNECT POWER TO NETWORK MODULE (DC POWER SUPPY, OR POWER OVER ETHERNET)
Connect power supply to DC Input, or connect PoE network cable to PoE connection
„
STEP 3: CONNECT THE DATA/POWER OUTPUT FROM NETWORK MODULE TO 2.0 AVT ISOLATION MODULE
Connect wires into pluggable screw terminal connectors on network module and the 2 .0 AVT
„
isolation module . The connector ports are labeled "AVT" .
STEP 4: CONNECT NETWORK CONNECTION TO RJ-45 PORT
if using the DC Input connector for power, and not using PoE, connect RJ-45 network cable,
„
if using PoE, connect the PoE network cable to RJ-45 port
„
STEP 5: BEFORE POWER-UP, READ DOCUMENT B21110 (2.0 AVT INSTRUCTION MANUAL) AND DOCUMENT B21176
(NETWORK MODULE USER GUIDE) FOR USER AND WEB-INTERFACE INSTRUCTIONS. POWER UP THE SYSTEM.
10/16/2022
135 x 112 x 28 mm (5 .3 x 4 .4 x 1 .1 inches), when network connetion is installed
Hazardous Locations
The equipment shall be installed in an enclosure that provides a degree of protection not less than
„
IP 54 in accordance with IEC 60079-0 .
Ambient Temperature Range: -25°C ≤ Tamb ≤ 60°C
„
The enclosure must only be accessible with use of a tool .
„
NOTE*:
For mounting the network module flat in an enclosure,
use the hole pattern locations identified by "A" in the
diagram . Use four #6 [M3 .5] pan head screws or
other compatible fasteners .
5
IF DESIRED, ATTACH NETWORK MODULE
TO THE 2 .0 AVT ISOLATION MODULE USING
SCREWS PROVIDED WITH THE NETWORK
MODULE
1006772, B21148_EN_rev1
Advertisement
