Table of Contents
Advertisement
13. TROUBLESHOOTING
WARNING! Refer to Safety chapters.
13.1 What to do if...
Problem
You cannot activate or
operate the oven.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The lamp does not operate.
The display shows F111.
The display shows an error
code that is not in this table.
Steam and condensation
settle on the food and in the
cavity of the oven.
The appliance is activated
and does not heat up. The
fan does not operate. The
display shows "Demo".
13.2 Service data
If you cannot find a solution to the
problem yourself, contact your dealer
or an Authorised Service Centre.
We recommend that you write the data here:
Model (MOD.)
Product number (PNC)
Serial number (S.N.)
Possible cause
The oven is not connected to an
electrical supply or it is connected
incorrectly.
The oven is deactivated.
The clock is not set.
The necessary settings are not set.
The Child Lock is on.
The door is not closed correctly.
The fuse is blown.
The lamp is defective.
The plug of the core temperature
sensor is not correctly installed into
the socket.
There is an electrical fault.
You left the dish in the oven for
too long.
The demo mode is activated.
........................................................................................................................................
........................................................................................................................................
........................................................................................................................................
Remedy
Check if the oven is correctly connected to the
electrical supply (refer to the connection diagram
if available).
Activate the oven.
Set the clock.
Make sure that the settings are correct.
Refer to "Using the Child Lock".
Fully close the door.
Make sure that the fuse is the cause of the
malfunction. If the fuse is blown again and again,
contact a qualified electrician.
Replace the lamp.
Put the plug of the core temperature
sensor as far as possible into the socket.
• Deactivate the oven with the house fuse or the
safety switch in the fuse box and activate it again.
• If the display shows the error code again, contact
the Customer Care Department.
Do not leave the dishes in the oven for longer than
15 - 20 minutes after the cooking process ends.
Refer to "Basic Settings" in "Daily use" chapter.
The necessary data for the service centre
is on the rating plate. The rating plate is
on the front frame of the appliance cavity.
Do not remove the rating plate from the
appliance cavity.
English
41
Advertisement
Table of Contents
