Table of Contents
Advertisement
Site
Motion Zone
Motion Sensitivity
Key Tone
Remote Controller ID
Sensor
Software Triger
4-4-1. Digital Deterrent
Trigger audio message via motion detection or sensor.
Select specified channel for motion zone setup.
Select either Full Zone or Partial Zone for motion detection. (Refer
to #33)
Press the right button of mouse to exit from Motion Zone grid
screen.
Set the motion sensitivity for the selected channel.
Control the motion sensitivity from 1 to 9. (1 : Low, 9 : High)
Enable/disable key tone.
Set the remote control ID.
1. Select ID.
2. Input the remote control ID number. (0 is all)
3. An icon will indicate on the Live Screen if the remote control ID is
synchronized. The options are from 0 to 99
Select the type of each sensor.
Option is Off, Normal Open or Normal Close.
Remote trigger channels. User can set the channels that want to
make a sensor recording through remotely with Software record
mode.
Figure 4.4.2. Digital Deterrent setup screen
28
Advertisement
Table of Contents
