Notice : VN series can use UTC feature.
: UTC(Up To Coax) allows for control of the camera's OSD menu via the coax cable.
User does not need extra connection via RS-485 to control the camera's OSD menu
-
How to set (Setup > Device > PTZ & Controller > UTC General)
4-4-3. Spot Out
Item
Spot Out
Spot Type
Spot On Event
Spot Event
Dwell Time
Sequence
Figure 4.4.6. Setup – UTC Camera Protocol
Figure 4.4.7. Spot-Out Setup Screen
Table 4.4.3. Menu Item in Spot-Out Setup Screen
Only 1 Spot Out is available to use.
Spot 1 supports only Full type. (1 channel only)
Enable/disable channel change if an event occurs on a channel.
Set the dwell time for the display of the event activated channel.
(3-10 sec)
Enable/disable sequential display of spot channel in full screen.
If select "on", the selected channel will be displayed on the monitor
Description
31