Table of Contents
Advertisement
②
Open the PTZ sub menu by selecting the submenu button.
Note: Connect PTZ cameras that support RS-485 directly to the RS-485 port. If the camera is controlled
through an RS-232C interface, use an RS-232C to RS-485 to RS-232C signal converter.
Use the PTZ setup screen to select the following options for the camera PTZ controller:
-
Channel: Channel connected to a PTZ device
-
Camera: Protocol Type
-
Speed: 19200, 14400, 9600, 4800, 2400 (Baud rate)
-
ID: 0-63
Controller (Keyboard Controller): If a PTZ controller is used, select a controller protocol from Controller
menu. Set Speed (Baud Rate) and ID number.
Figure 4.4.3. Sensor, Alarm & RS-485 Ports
Figure 4.4.4. PTZ Control Setup Screen
Figure 4.4.5. Controller Selection Screen
30
Advertisement
Table of Contents
