Table of Contents
Advertisement
Maintenance
Maintenance
Contact the factory, the factory representative or a local service company to perform maintenance and repairs.
Disconnect the power supply to the appliance before cleaning or servicing.
Daily
1. Wash exposed cleanable areas.
Monthly
1. Blower wheel inlet and motor air vent should be cleansed if an accumulation of dust or lint is obvious.
Twice a Year (minimum)
1. Have an authorized service person clean and adjust the unit for maximum performance.
2. The unit venting system should be examined and cleaned.
3. Grease the screw jack tilt mechanism via the lubricating nipple. Use Petro-Canada type OG-2 or equivalent.
Annually
1. Have an authorized service person inspect the screw jack assembly for wear. The screw must be replaced
immediately if the end play has reached 0.019" [0.5mm].
Under normal operating conditions a "try lever test" should be performed every two months. Under severe service
conditions, or if corrosion and/or deposits are noticed within the valve body, testing must be performed more often.
A "try lever test" should also be performed at the end of any non-service period.
Hot, high pressure fluid may be discharged from body drain and vent during "try lever" test.
Test at, or near, half of the operating pressure by holding the test lever fully open for at least two seconds to flush
the valve seat free of sediment and debris. Then release lever and allow the valve to snap shut.
If lift lever does not activate, or there is no evidence of discharge, turn off equipment immediately and contact a
licensed contractor or qualified service personnel.
14
PAGE
OF 28
Safety Valve Maintenance and Testing
Care must be taken to avoid any bodily contact.
High sound levels may be experienced during "try lever" test.
Wear proper safety equipment and exercise extreme care!
INSTALLATION & OPERATION MANUAL 10201 REV 2 (08/22)
NOTICE
WARNING
CAUTION
CAUTION
CAUTION
Gas Tilting Kettle
Advertisement
Table of Contents
