Quick Reference Guide - µ-Dimension D3204 User Manual

QUICK REFERENCE GUIDE

Use this section for a quick reference for an overview of the operational features
of the D3204 Multizone Controller. For customizing features, please refer to the
Programming/Operation section of the manual.
CALL SCENE:
called or activated.
• Press a SCENE button (refer to Figure 4) to call or activate a programmed
scene.
ADJUST ZONE LIGHT LEVEL:
percentage of light level for selected zones.
• Press the Zone Dim/Bright buttons to increase or decrease the percentage
of light level for individual zones (refer to Figure 4).
• Press the Dim Scene buttons to increase or decrease the percentage of
light level for all zones (refer to Figure 4).
CHANGE SCENE BANK:
scenes can be accessed and which SCENE buttons will control those scenes
(01-08, 09-16, 17-24 and 25-32).
• Press the Function button (refer to Figure 4) to toggle though the Scene
Banks (01-08, 09-16, 17-24 and 25-32) and then press a SCENE button to
activate that bank.
PROGRAMMING SCENE:
• Press and hold down a SCENE button of the scene to be programmed for
approximately 8 seconds until scene button blinks to access program
mode.
• Press the Dim/Bright buttons to turn lighting loads ON, OFF, or adjust
percentage of lighting level to desired level (refer to Figure 4).
• Press SCENE button again to set scene.
• Repeat steps for additional scenes.
NOTE: For Name and Fade Rate programming, refer to program and operation
of the Scene Wizard.
Used to choose which of the 32 programmed scenes are to be
Use to choose which of the 32 programmed
Used to program to desired scenes.
QUICK REFERENCE GUIDE
Used to increase or decrease the
5