Input Fuse And Supply Wire Considerations - Lincoln Electric FlexCut 200 Operator's Manual

WARNING
ELECTRIC SHOCK CAN KILL.
ONLY A QUALIFIED ELECTRICIAN SHOULD
CONNECT THE INPUT LEADS TO THE
F . CONNECTIONS SHOULD BE MADE
IN ACCORDANCE WITH ALL LOCAL AND
NATIONAL ELECTRICAL CODES AND THE CONNECTION
DIAGRAM LOCATED ON THE INSIDE OF THE
RECONNECT/INPUT ACCESS DOOR OF THE MACHINE.
FAILURE TO DO SO MAY RESULT IN BODILY INJURY OR
DEATH.
ALWAYS CONNECT THE GROUNDING LUG (LOCATED AS SHOWN IN
FIGURE A.1) TO A PROPER SAFETY (EARTH) GROUND.
Input Cord Strain Relief
Route input cord through
relief and twist nut to tighten.
FIGURE A.1
Power Connection Block
Connect each phase of a three
phase connector here
Ground Connection
Connect Ground Lead per local
and national electrical codes
INPUT FUSE & SUPPLY WIRE CONSIDERATIONS
INSTALLATION