Datalogic Joya Touch 22 User Manual page 46

SETTINGS
Double Read Timeout
To prevent a double read of the same label, the
mum time allowed between reads of labels of the same symbology and data. If the unit
reads a label and sees the same label again within the
ond read of the label will be ignored.
scan mode.
Enable Target Mode
If enabled, when the scan button is pressed, the scanner will project an aiming pattern
to assist in centering over the barcode before scanning.
Target mode
Tap
Spot Timeout
Scanning takes place after a programmable time upon pressing the scan button. Tap
Target timeout
Release Scan
Scanning takes place after the scan button is released. Drag the
slider to set the scanning timeout after releasing the scan button:
Decode Timeout
Drag the
attempts to decode after target timeout:
40
JOYA™ TOUCH 22
to select the desired targeting behavior:
to set the duration of the spot:
Decode timeout slider to set the maximum amount of time the scanner
Double Read Timeout
Double Read
Double Read Timeout
sets the mini-
Timeout, the sec-
does not apply to Single
Release scan timeout