Isuzu 2008MY N Series Workshop Manual page 98

Step
Important: Replacement fuel injector must be
programmed.
Replace the appropriate fuel injector that does not
17
change engine speed when commanded OFF.
Refer to Injector in Section 1D Engine Fuel.
Did you complete the replacement?
Important: The fuel supply pump must be timed to
the engine and adjustment value must be learned
to the ECM.
Notice: Always replace the fuel filter element when
18
a fuel supply pump is replaced.
Replace the fuel supply pump and fuel filter
element. Refer to Fuel Supply Pump and Fuel Filter
Element in Section 1D Engine Fuel.
Did you complete the replacement?
1. Reconnect
harness connector(s).
2. Clear the DTCs with a scan tool.
3. Turn OFF the ignition for 30 seconds.
4. Start the engine.
19
5. Operate the vehicle within the Conditions for
Running the DTC. You may also operate the
vehicle within
observed from the Freeze Frame/ Failure
Records.
Did the DTC fail this ignition?
Observe the DTC Information with a scan tool.
20
Are there any DTCs that you have not
diagnosed?
Action
all previously disconnected
the conditions that
Engine Control System (4HK1)
Value(s)
—
—
—
you
—
Yes
Go to Step 19
Go to Step 19
Go to Step 2 Go to Step 20
Go to DTC List
1A-95
No
—
—
System OK