Isuzu 2008MY N Series Workshop Manual page 252

Step
1. Reconnect
harness connector(s).
2. Clear the DTCs with a scan tool.
3. Turn OFF the ignition for 30 seconds.
4. Start the engine.
6
5. Operate the vehicle within the Conditions for
Running the DTC. You may also operate the
vehicle within
observed from the Freeze Frame/ Failure
Records.
Did the DTC fail this ignition?
Observe the DTC Information with a scan tool.
7
Are there any DTCs that you have not
diagnosed?
Action
all previously disconnected
the conditions that
Engine Control System (4HK1)
Value(s)
—
you
—
Yes
Go to Step 2 Go to Step 7
Go to DTC List
1A-249
No
System OK