Zennio ALLinBOX 1612 v2 Manual page 9

Overload LED (OVERLOAD): notifies a high consumption in the power
supply.
➢ OFF: device with low power consumption.
➢ ON (red): device with too high consumption.
➢ BLINKING (green): short circuit in the power supply.
Programming LED:
➢ OFF = normal operation.
➢ ON (red) = programming mode active.
IP Factory Reset LED:
➢ OFF: normal operation.
➢ ON (red): IP restored by DHCP.
➢ ON (green): static IP (of ETS configuration) restored.
➢ ON (yellow): IP restored by APIPA.
Note: Please refer to section 1.5 for further details.
Reset LED:
➢ OFF: normal operation.
➢ ON (red): while the button is pressed (power supply is reset) and short
circuit in the power supply.
http://www.zennio.com Technical Support: http://support.zennio.com
ALLinBOX 1612 v2
9