Advertisement
Available languages
Available languages
OPERATION
Instructions for Use
WARNING: Always observe the safety instructions and applicable regulations.
WARNING: To reduce the risk of serious personal injury, turn tool off and
disconnect battery pack before making any adjustments or removing/
installing attachments or accessories. An accidental start-up can cause injury.
Installing and Removing the Battery Pack (Fig. B)
nOTE: For best results, make sure your battery pack is fully charged.
IMPORTanT: To avoid battery charge depletion, remove the battery pack from the
D
WALT USB charger when not in use.
e
Over‑Discharge Protection
Over‑discharge protection will completely shut down the USB charger and require the
user to remove the battery pack for at least 5 seconds and re‑insert into the D
charger to use again. The user should ensure they see the power‑up blink pattern upon
insertion to ensure proper operation.
To Install Battery Pack
Slide the battery pack
firmly seated.
WARNING: Fire hazard. Do not store or carry the battery pack so that metal
objects can contact exposed battery terminals.
To Remove the Battery Pack
Press the battery release button
USB Charging Ports (Fig. A)
The D
WALT USB charger
e
Type‑C Port
.
5
Type‑C port supports: Source – Power Delivery 3.0, Qualcomm
AFC, BC 1.2, Type C only
‑ Sink – BC 1.2, Apple
‑ USB Type C can sink or source up to 100W
Type‑a port supports: BC1.2 and Apple FastCharge and Samsung™ FastCharge (AFC).
Output only. USB Type‑A port capable of 12W.
1
into the D
WALT USB charger
e
and pull the USB charger from the battery.
2
is equipped with a USB Type‑A port
3
****
charging, PD 3.0, Type C only
3
until the battery pack is
and a bi‑directional USB
4
QC3.0/2.0, Samsung™
***
EnGLIsh
WALT USB
e
49
Advertisement
