Lenovo ThinkPad SL300 2738 Supplementary Manual page 23

Message
8801: Warning!
Port 60h/64h
emulation is not
supported by this
USB Host Controller!
8802: Warning!
EHCI controller
disabled. It requires
64bit data support in
the BIOS.
8900: Not enough
space in Runtime
area!!. SMBIOS data
will not be available.
8A00: Warning!
This system board
does not support the
power requirements
of the installed
processor. The
processor will be run
at a reduced
frequency, which
will impact system
performance.
8B00: Insufficient
Runtime space for
MPS data! System
may operate in PIC
or Non-MPS mode.
Beep errors
One beep and a
blank, unreadable, or
flashing LCD
One long and two
short beeps, and a
blank or unreadable
LCD
Two short beeps
with error codes
Two short beeps and
a blank screen
Solution
This message is displayed to indicate that port 60h/64h
emulation mode cannot be enabled for this USB host controller.
This condition occurs if USB KBC emulation option is set for
non-SMI mode.
This message is displayed to indicate that EHCI controller is
disabled because of incorrect data structure. This condition
occurs if the USB host controller needs 64-bit data structure
while the USB is ported with 32-bit data structure.
This message is displayed when the size of the SMBIOS data
exceeds the available SMBIOS runtime storage size.
This message is displayed when the power requirements of the
board do not match the power requirement of the CPU.
This message is displayed when there is not enough space in
the 0F000h runtime area for creating MPS table.
If an external monitor is attached, confirm that the cable of the
external monitor is connected to the system. If the problem
persists, contact the administrator.
Confirm that the memory cards have been installed correctly. If
the problem persists, contact the administrator.
Refer to POST error or POST message.
Confirm that the memory cards have been installed correctly. If
the problem persists, contact the administrator.
Chapter 3. Solving computer problems
15