Table of Contents
Advertisement
PIN function
When this function is enabled, depending on the mobile terminal to be used, the entry of PIN may be
required for connection. If this is the case, enter the 8-digit PIN number displayed at the bottom of the
screen.
Standby screen when [Wireless Display] is set to [On]
"DIRECT-" is appended to the head of SSID.
PIN display
Note
• The Wireless Display function can be used only when the mobile terminal supports Miracast.
If connection fails, check if the operating system in use supports Miracast.
For operation method for the mobile terminal, refer to the user's manual, etc. of your terminal.
• When [Multicast] is set to [On], the Wireless Display function cannot be used. Accordingly, [Wireless Display] cannot
be set to [On].
• Re-pairing is required when the firmware version of the receiver is upgraded from 1.12412.676 or older to
1.14366.852 or later, and [Wireless Display] is set from [Off] to [On] to use the transmitter.
• The Wireless Display function cannot be executed during Lock mode by the transmitter.
• When [Wireless Display] is set to [On], the following menu item is disabled.
- Max Connection
• When [Wireless Display] is set to [On], the following menu items cannot be changed.
- Hide SSID / Turn Off SSID
The setting is forcibly set to [Off].
- Password
• When the firmware version of the receiver is upgraded from 1.12412.676 or older to 1.14366.852 or later, it is
necessary to download the module of the Wireless Display function via Internet connection.
Starting up the receiver connected to the Internet automatically downloads the modules. After downloading is
complete, the Internet connection is not necessary.
If the modules have not been downloaded, the following message is displayed for a few seconds at the startup of
the receiver.
English
37
Advertisement
Table of Contents
