Hitachi D 10VH Safety Instructions And Instruction Manual page 12

English
10. A t t ach i n g
accessory)
For hook (side-attaching) (Fig. 7)
Fix the hook firm ly on the desired side of
the gear cover using M 10 bolt w hich is
supplied w ith hook.
For hook (A) (top-attaching) (Fig. 8)
To attach the hook (A), it is necessary to
d i sassem b l e t h e h an d l e p o r t i o n w h i ch
covered the tool's electrical system. For your
co n t i n u ed saf et y an d el ect r i cal sh o ck
protection, installing the hook (A) on this
d r i l l sh o u l d ON LY b e p er f o r m ed b y a
HITACHI AUTHORIZED SERVICE CENTER.
CAUTION:
When the pow er tool is used w ith a hook
fixed to it, pay attention to the follow ing
points:
Before hanging the main unit from the waist
belt, make sure that the drill has come to a
complete stop.
While it is suspended from the w aist belt,
the pow er plug must be disconnected from
the pow er source.
Do not w alk about w ith the pow er tool
hanging from the w aist belot.
In the case of operation in a high place, it is
dangerous to drop the tool accidentally. If
the hook is deformed or hung from the
w rong position, there is danger that the
hook w ill slip off and the tool w ill fall.
Be careful to avoid danger.
In making a through hole, the pow er tool
som et im es shakes violent ly w hen t he
w orkpiece is pierced, from example. Be
careful you are not hurt by the hook even if
such situation happens.
12
This manual downloaded from http://www.manualowl.com
t h e h o o k. (Op t i o n al
Loosen Tighten
Fig. 6
M 10 Bolt
Hook
Fig. 7
Fig. 8
Side handle
Hook (A)