Levenhuk Atom Digital DNM200 User Manual page 3

Levenhuk Atom Digital DNM200 Night Vision Monocular
EN
Never, under any circumstances, look directly at the Sun, another bright source of light, or at a laser through this
device, as it may cause PERMANENT RETINAL DAMAGE and may lead to BLINDNESS.
Specifications
Magnification, x
Objective lens diameter, mm
Close focus, m/ft
Observation distance, m/ft
Tripod adapter thread
Operating temperature range, °C/°F
IR-illumination
IR wavelength, nm
Recording time with illumination (IR), h
Recording time without illumination (IR), h
Power supply
Operation voltage
Storage
Image format and resolution
Video format and resolution
Dimensions, mm/in
Weight, g/lb
The manufacturer reserves the right to make changes to the product range and specifications without prior notice.
Getting started
This device has a built-in 8GB MicroSD card. A photo or video will be saved automatically.
Install batteries
Open the battery compartment cover and insert the battery according to the correct polarity marks. Close the cover.
Button panel and device settings
ON/OFF/OK button
Press and hold the ON/OFF/OK button for 3 seconds to turn the device on or off.
Turn the focusing wheel to adjust the focus.
Button functions: 1) takes a picture in Photo mode; 2) starts and stops video recording in Video mode; 3) enters the sub-menu.
Notes:
•
If the device fails to activate, check for defective or improperly installed batteries. Always only use the recommended batteries.
•
If you wear glasses, keep them on while using the device.
•
Video is recorded without sound.
UP button / DOWN button
Button functions: 1) IR brightness level up/down; 2) Zoom in/out; 3) scroll the menu.
IR button
If the light is insufficient or when used in the evening, turn on the IR by pressing the IR button. The image will change from color to
black and white. You may select the brightness level from 1 to 6. The brightness values will be displayed on the LCD screen.
Notes:
•
Do not use IR in daylight (when IR is on, you will have a color image, when IR is off — black and white image).
•
If the battery power is not enough, the IR LED level will lower automatically. If only half power is left, the max. brightness level is 5.
If only 25% power is left, the max. brightness level is 3. If the battery power is lower than 25%, the IR LED cannot be activated.
1–8 (digital), 5 (optical)
43
5/16
100 (in complete darkness)
3–400 (in weak light) /
328 (in complete darkness)
10–1312 (in weak light)
1/4"
−20...+60 (operating), −30...+70 (storage)/
−4...+140 (operating), −22...+158 (storage)
IR LEDs 3W (6 brightness levels)
715
6
10
18650 battery
3.7V
built-in 8GB SD-card
JPEG, 1920x1080px
MP4, 1920x1080px@30fps
222x82x66 / 8.7x3.2x2.5
500 / 1.1
3