Introduction - Trane CITY RTSF Series Manual

Foreword
These instructions are given as a guide to good practice in the installation, start-up, operation, and maintenance
by the user, of Trane City chiller RTSF , manufactured in France. A separate manual is available for the use and
maintenance of the unit's control, Tracer™ UC800. They do not contain full service procedures necessary for the
continued successful operation of this equipment. The services of a qualifi ed technician should be employed through
the medium of a maintenance contract with a reputable service company. Read this manual thoroughly before unit
start-up.
Units are assembled, pressure tested, dehydrated, charged and tested in accordance with factory standard before
shipment.
Warnings and Cautions
Warnings and Cautions appear at appropriate sections throughout this manual. Your personal safety and the proper
operation of this machine require that you follow them carefully. The constructor assumes no liability for installations
or servicing performed by unqualifi ed personnel.
WARNING: Indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury.
CAUTION: Indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate injury.
It may also be used to alert against unsafe practices or for equipment or property-damage-only accidents.
Safety Recommendations
To avoid death, injury, equipment or property damage, the following recommendations should be observed during
maintenance and service visits:
1. The maximum allowable pressures for system leak testing on low and high pressure side are given in the
chapter "Installation" . Insure to do not exceed test pressure by using appropriate device.
2. Disconnect all power supplies before any servicing on the unit.
3. Service work on the refrigeration system and the electrical system should be carried out only by qualifi ed and
experienced personnel.
4. To avoid any risk, it is recommended to place the unit on an area with restricted access.
Reception
On arrival, inspect the unit before signing the delivery note. Specify any visible damage on the delivery note,
and send a registered letter of protest to the last carrier of the goods within 7 days of delivery.
Notify the local TRANE sales offi ce at the same time. The delivery note must be clearly signed and countersigned
by the driver.
Any concealed damage shall be notifi ed by a registered letter of protest to the last carrier of the goods within 7 days
of delivery. Notify the local TRANE sales offi ce at the same time.
Important notice: No shipping claims will be accepted by TRANE if the above mentioned procedure is not respected.
For more information, refer to the general sales conditions of your local TRANE sales offi ce.
Note: Unit inspection in France. Delay to send registered letter in case of visible and concealed damage is only
72 hours.
Loose Parts Inventory
Check all the accessories and loose parts that are shipped with the unit against the shipping list. Included in these
items will be the Water Flow Switch (optional), rigging and electrical diagrams, service literature, which are placed
inside the control panel and/or starter panel for shipment.
If optional elastomeric isolators are ordered with the unit they are shipped mounted on the horizontal support frame
of the chiller. The isolators' location and distribution weight diagram is placed with the service literature inside the
starter/control panel.
RLC-SVX023B-GB

Introduction

3