Mounting; Troubleshooting - La Crosse Technology WS-7213U Instruction Manual

E.
VIEWING AND OPERATING WITH MULTIPLE REMOTE SENSOR UNITS
To view the temperature of a different remote sensor unit, press and release the "CH" button. A shift from one "boxed" number to the next should
be observed in the OUTDOOR LCD.
1.
To view the Minimum/Maximum temperature: first select from which remote temp/humidity sensor to read data from (indicated by the
"boxed" number). Pressing and releasing the "MIN/MAX" button will toggle through the minimum and maximum indoor temperature, and the
minimum and maximum outdoor temperature.
2.
To reset the Minimum/Maximum readings, press and hold the "MIN/MAX" button for five seconds.

MOUNTING

Note: To achieve a true temperature reading, avoid mounting in direct sunlight. We recommend that you mount the remote temp/humidity sensor
on an outside North-facing wall. The sending range is 80ft; obstacles such as walls, concrete, and large metal objects will reduce the range. Place
both units in their desired location temporarily to test reception capability before permanently mounting.
A.
REMOTE TEMP/HUMIDITY SENSOR
1.
Remove the mounting bracket from the remote temp/humidity sensor
2.
Mount using either screws or adhesive tape.
3.
Reattach the remote temp/humidity sensor to the mounting bracket.
B.
THE WEATHER STATION
1.
The indoor weather station comes with the table stand already mounted. If you wish to use the table-stand, all that is required is to place the
indoor weather station in your desired location.
2.
To wall mount:
a)
Remove the table stand by pulling down on the stand from the rear and rotating forward.
b)
Fix a screw (not included) into the desired wall.
c)
Place the indoor weather station onto the screw using the hanging hole on the backside.
d)
Gently pull the indoor weather station down to lock the indoor weather station into place.

TROUBLESHOOTING

NOTE: For problems not solved, please contact La Crosse Technology via e-mail or phone, or visit our website, www.lacrossetechnology.com
Problem: The LCD is faint
Solution: Replace batteries
Problem: No outdoor temperature or humidity is displayed.
Solution:
1) First try to re-establish communication between the remote sensor and indoor weather station by moving both units to within three to five feet of
each other. Wait about ten minutes and then check for a temperature and humidity.
2) If this does not work please remove the batteries from both units and restart the system (please see Detailed Set-up on page nine through
eleven).
Note: Please make sure when restarting the system that all batteries are fresh.
3) Once the system has been reset and you have a temperature and humidity reading from the sensor, temporarily place the remote temp/humidity
sensor in the previous location.
Note: If there is a outdoor temperature and humidity displayed when the two units are close together there was either too much distance between the
two units previously or some type of interference that was causing poor reception.
4) If after 15 minutes the temperature and humidity are not displayed you will need to choose another location for placement of the temp/humidity
sensor.
5) The best way of doing this is to move the sensor 10 feet closer to the indoor weather station.
6) After moving the remote temp/humidity sensor please wait 15 minutes to give the indoor weather station time to re-acquire the signal.