Etrel INCH LITE Quick Start Manual
Hide thumbs Also See for INCH LITE:

Advertisement

Quick Links

Ver. 2020-08-EN
Etrel INCH LITE
EN
QUICK START GUIDE

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the INCH LITE and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Etrel INCH LITE

  • Page 1 Ver. 2020-08-EN Etrel INCH LITE QUICK START GUIDE...
  • Page 3: Safety Instructions

    SAFETY INFORMATION Etrel INCH LITE charging station has been designed and tested in accordance with current and past versions of international standards. The charging station is compliant with IEC 61851...
  • Page 4 I N T E N D E D U S E • Etrel INCH LITE charging station is intended only for charging of electric vehicles and should not be used to charge other appliances or for any other purpose. •...
  • Page 5: Base Specifications

    • Do not operate the charging station with wet hands. • The charging station manufacturer cannot be made liable for damage or injury caused by improper handling, installation, or use of the product. • Any usage of the product not covered in this document is not allowed and could cause injury or death.
  • Page 6 G R O U N D I N G I N S T R U C T I O N S Etrel INCH LITE charging station needs to be properly grounded to allow safe use. In the case of malfunction or breakdown, grounding provides protective measure to reduce the risk of electric shock.
  • Page 7: Installation Procedure

    • 9 × screws to mount the bracket to the wall, Screws dimensions: 4.5x40 and 4.5x60 [mm], • Cable gland rubber seal for smaller cable dimensions • *9 × wall spacers • *2 × keys to open charging station service doors, •...
  • Page 8 mounting bracket so that the holes will be marked at the correct positions when used. If power supply cables come through the wall, a hole for the power supply cables needs to be drilled first. You should drill the hole in the position shown on the picture.
  • Page 9 After the removal of doors untighten the screws on the plate with cable glands and remove the plate. If using the bigger gland, make sure that the rubber inside the gland is of correct size. For the cables with dimensions up to 5x6 mm use the tighter rubber seal.
  • Page 10 Mount Charging Station on Holder and Screw the Cable Gland on the Enclosure Mount the station on the holder which is already attached to the mounting bracket. Holder is strong enough to hold the charging station during the installation of cables. Place the gland plate in its position so that the plate holes are aligned with holes of the enclosure.
  • Page 11 Attach the Service Doors and Remove the Holder Attach the back-maintenance doors back onto the enclosure and use the screw to secure it. Remove the charging station off the holder and remove the holder from the bracket. While doing this, hold the charging station firmly as it is not supported anymore.
  • Page 12 WEEE: Dispose of the device only at the recycling centre. 2020 Etrel. All rights reserved. Etrel, the Etrel logo and other marks are owned by Etrel and may be registered. All other trademarks are the property of their respective owners. Etrel assumes no responsibility for any errors that may appear in this manual.

Table of Contents