Care And Maintenance - Lavor MISSISSIPPI R Manual

EN
coupling fully down and then screw into place
by hand without the aid of tools.
• Connect the high pressure hose to the gun.
• Turn the water tap fully on. The water
temperature absolutely must be below 40°C.
IMPORTANT: The washer machine has to
operate with clean water in order to avoid any
damages to the washer machine itself.
• Release the gun safety catch and keep the
trigger pressed, allowing the water to flow until
all the air has been expelled.
• Fit the lance into the gun.
• Fit the nozzle into the lanxce.
• Connect the plug to the power socket.
> 1ST START-UP
When starting up for the first time or after a long pe-
riod out of use, connect the intake line only for a few
minutes so that any dirt is vented from the delivery
outlet
> START-UP
(fig. E)
• Whenever using the high-pressure cleaner, users are
urged to hold the gun in the correct position, with one
hand on the grip and the other on the spray rod.
> TO WASH WITH COLD WATER
To start the machine, press the gun trigger
and at the same time turn the master switch ①
to "ON"
> TO WASH WITH HOT WATER
To wash with hot water, press the switch ②
and turn the thermostat ③ to the desired
temperature setting.
• WARNING: In case of operation indoors,
adequate ventilation and gas venting must be
assured.
> DETERGENT SUCTION
at low pressure (if included)
(see fig. F)
The adjusting head allow you to select water jet at
low and high pressure. The pressure selection is car-
ried out by rotating the adjusting head. To increase
the pressure, rotate the adjusting head clockwise,
to reduce the pressure rotate it anti-clockwise. The
22
detergent suction is automatic when the adjusting
head of the lance is rotate for low pressure operation
(anti-clockwise).
> DETERGENT SUCTION
at hght pressure (if included)
- BUTTON LOCATED ON THE ELECTRICAL
PANEL (OPTIONAL mod.DP)
Operate the button, press the gun: the deter-
gent is mixed with high pressure water.
• CAUTION: Make use only of liquid detergent, do not
absolutely use acid or too much alkaline products.
We suggest you to make use of our products, which
have been studied for the use with washer machines.

CARE AND MAINTENANCE

SCHEDULED MAINTENANCE PLAN
Visit www.lavorservice.com website and
download the scheduled maintenance plan.
(fig. G)
IMPORTANT: Before doing any work
on the cleaner, discharge the pressure
and disconnect the electricity and water
supplies.
• WARNING: Do not spray the appliance
with water and do not use detergents or
aggressive solvents. Machine could be
damaged.
·
Clean the exterior part of the machine with a dry
cloth.
> STORAGE
· Move the machine only by grasping the
carrying handle
· Store the appliance and the accessories in a
dry room.
· Store the appliance and the entire accessories
in a frost-safe room.
CHECKING THE PUMP OIL LEVEL
Check the oil level periodically. The oil must be
changed for the first time after 50 working hours,