Advertisement
Quick Links
USER GUIDE
LOGIC MAX HEAT
2
H12 H15 H18 H24 H30
When replacing any part on this appliance, use only spare parts that you can be assured conform to the safety and performance
specification that we require. Do not use reconditioned or copy parts that have not been clearly authorised by Ideal Heating.
For the very latest copy of literature for specification and maintenance practices visit our website idealheating.com
where you can download the relevant information in PDF format.
October 2022
User Guide
3
UIN 228292 A05
Advertisement
Related Manuals for Ideal Heating LOGIC MAX HEAT2 H12
Summary of Contents for Ideal Heating LOGIC MAX HEAT2 H12
- Page 1 When replacing any part on this appliance, use only spare parts that you can be assured conform to the safety and performance specification that we require. Do not use reconditioned or copy parts that have not been clearly authorised by Ideal Heating.
-
Page 2: Table Of Contents
Benchmark Commissioning Checklist. You can check your installer by calling Gas Safe Register direct on 0800 4085500. Ideal Heating is a member of the Benchmark scheme and fully supports the aims of the programme. Benchmark has been introduced to improve the standards of installation and commissioning of central heating systems in the UK and to encourage the regular servicing of all central heating systems to ensure safety and efficiency. -
Page 3: Boiler Operation
BOILER OPERATION OPERATION MODES Winter Conditions - (Central Heating and Domestic Hot Water required) If a Boiler symbol is shown on the display then press Mode until either Ready or On is shown under the Boiler symbol. If Tap & Radiators symbols are shown then press Mode until On at 60°C Ready or On is shown under the radiator and tap symbol. -
Page 4: Points For The Boiler User
FROZEN CONDENSATE DRAIN WEATHER COMPENSATION When the Weather Compensation option is fitted to the system then the central heating temperature knob (B) becomes This appliance is fitted with a siphonic condensate trap a method of controlling room temperature. Turn the knob system that reduces the risk of the appliance condensate clockwise to increase room temperature and anti-clockwise from freezing. -
Page 5: General Information
GENERAL INFORMATION ESCAPE OF GAS MINIMUM CLEARANCES Should a gas leak or fault be suspected contact the Clearance of 165 mm (6 ”) above, 100 mm (4”) below, 2.5 National Gas Emergency Service without delay. ”) at the front of the mm (9 ”) at the sides and 450 mm (17 Telephone 0800 111 999. -
Page 6: Display Functions - Normal Operation Mode
DISPLAY FUNCTIONS - NORMAL OPERATION MODE NORMAL OPERATION SCREENS WITH OUTSIDE SENSOR WITHOUT OUTSIDE SENSOR How to adjust Boiler Temperatures Off Mode Winter Mode, DHW Demand Off Mode On at 60°C Ready To Switch On Radiator Target 60°C To Switch On Target 60°C Press Mode Button &... -
Page 7: Display Functions - Fault Messages
DISPLAY FUNCTIONS - FAULT MESSAGES Overheat Lockout Outside Sensor Fault Spare PCB Not Set 1 With boiler off & system cold, fill system to 1.0bar. Contact Installer 2 Bleed radiators, refill system to 1.0bar. Contact Installer 3 Check radiator valves & boiler valves are open. - Page 8 At Ideal Heating we take our environmental impact seriously, therefore when installing any Ideal Heating product please make sure to dispose of any previous appliance in an environmentally conscious manner. Households can contact their local authority to find out how.