Hyundai HCOMBIBP50 Instructions Manual page 21

Mounting the throttle cable
- Remove the air filter cover.
- Place the throttle cable in the adjusting bolt. Be careful that the round hole of the rotating joint
faces the end of the inner wire.
- Leave the rotating seal and make sure that the inside wire is properly seated in the hole.
- Reinstall the cover of the air filter.
Handle
Install the front handle as shown in the image. Do not fix the screws until you have set the most
comfortable working position.
-Install the desired tube on the bar of the main unit. Make sure the locking pin is inserted into the hole
in the bar.
-Fasten the bar by turning the nut counter clockwise.