Hyundai HCOMBIBP50 Instructions Manual page 12

o Never place your hand near the rotating accessory. Accessory may kickback over your
hand.
o Do not position your body in the area where power tool will move if kickback occurs.
Kickback will propel the tool in direction opposite to the wheel's movement at the point of
snagging.
o Use special care when working corners, sharp edges etc. Avoid bouncing and snagging the
accessory. Corners, sharp edges or bouncing have a tendency to snag the rotating
accessory and cause loss of control or kickback.
Residual risks
Even if you use this product in compliance with all safety requirements, the potential risks of
injury and damage remain. The following hazards may arise in the structure and design of this
product. Always be vigilant when using this product, so you can recognize and manage the
risks rather. Rapid intervention can prevent serious injury and property damage.
- There are harmful health consequences resulting from the emission of vibrations if the
product is used for long periods of time or not properly managed and properly maintained.
- There is risk of injury and property damage due to attachments or broken the sudden
impact of hidden objects.
- Risk of injury to persons and property caused by flying objects.
- Prolonged use of this product exposes the operator to vibration and can produce so-
called "white finger" disease. To reduce the risk, wear gloves and keep your hands warm.
If any of the symptoms of "white finger syndrome" occur, seek immediate medical
attention. Symptoms of the "white finger" include numbness, loss of sensitivity, tingling,
tingling, and pain, loss of strength, colour changes or skin condition. These symptoms
usually appear on the fingers, hands or wrists. Risk increases at low temperatures
- Inhalation of particles
- Inhalation of exhaust gases
- Unattended projections
- Contact with foreign objects
- Contact with the tool in operation
- Hearing loss in the absence of correct hearing protection
To minimize those risks, follow the instructions of this manual about wearing personal equipment of
protection, take some rest during the operation and the manipulation of the tool. Do not work for a
prolonged time.
Intended use
1) Brushcutter and grass trimmer
Intended use
This machine can be used as a trimmer with the cutting edge, and as a brushcutter with
the cutting blade.
The grass trimmer must be strictly and only to cut grass or weeds that are not too dense.
The brush cutter must be used to cut hard grass, more dense weeds and small branches
with a maximum diameter of 10mm.
Improper use
This machine is not intended to cut bushes or others similar plants requiring the tool to
get off the ground. Do not use this tool to work other materials such as stones, clay soils,
etc.