Related Manuals for BUSCH R5 RE 0016 B
Summary of Contents for BUSCH R5 RE 0016 B
- Page 1 Installation and Operating Instructions Vacuum Pumps R5 RE 0016 B / RE 0040 B / RE 0063 B with safety valve, without motor 0870142823 /-0001 / 28.10.2021 / Original instructions...
-
Page 2: Table Of Contents
Oil....... . . 20 Busch – All over the World in Industry ....24... -
Page 3: Product Description
The provision of these features by Busch does not constitute any kind In order to avoid an ignition inside as well as outside the vacuum pump... -
Page 4: Operational Options / Use Of Optionally Available Equipment
550 barg and to shut down the vacuum pump at 600 barg (pres- that separates before the exhaust filter accumulates at the bottom of sure monitoring equipment does not form part of the Busch scope the bottom chamber of the oil separator (j). -
Page 5: Safety Notes
In case the vacuum pump is in a cardboard box cushioned with rolled the vacuum pump with conservation oil because of very adverse stor- corrugated cardboard: age conditions, seek advice from your Busch representative! ◆ Remove the corrugated cardboard from the box Version with gas ballast without ball-valve, with sinter metal filter: In case the vacuum pump is laid in foam: ◆... -
Page 6: Installation And Commissioning
In case of very long suction lines it is prudent to use larger line sizes in the vacuum pump such that it will start automatically when order to avoid a loss of efficiency. Seek advice from your Busch the oil sump temperature falls below the allowed temperature representative! –... -
Page 7: Electrical Connection / Controls
(separate leaflet) The discharged gas contains small quantities of vacuum oil. Note: The motor is not part of the Busch scope of delivery and is there- Staying in vacuum oil contaminated air bears a risk of damage to fore not subject to these instructions. -
Page 8: Recording Of Operational Parameters
● Make sure that the seal ring is inserted into the filling plug (g, o) The provision of these features by Busch does not constitute any kind and undamaged, replace if necessary of implicit approval or certification of the vacuum pump for the use in/with potentially explosive atmosphere. -
Page 9: Conveying Condensable Vapours
Flame arrestors must only be serviced by personnel that have re- consumables, approved for use in potentially explosive areas by ceived specific training for this purpose either by Busch or by the Busch, must be used exclusively. manufacturer of the flame arrestors. -
Page 10: Weekly
CAUTION Flame arrestors must only be serviced by personnel that have re- ceived specific training for this purpose either by Busch or by the During operation the oil separator is filled with hot, pressurised oil manufacturer of the flame arrestors. -
Page 11: Oil Life
● Fill in the flushing agent To select the oil best suited oil for your process please contact your Busch representative. ● Firmly reinsert the filling plug (g, o) If there is no experience available with regard to the oil life under the ●... -
Page 12: Exhaust Filter
Flame arrestors must only be serviced by personnel that have re- ceived specific training for this purpose either by Busch or by the ● Tighten the screw in the exhaust filter retaining spring such that manufacturer of the flame arrestors. -
Page 13: Removal From Service
During dismantling of the vacuum pump personal protective www.buschvacuum.com). equipment must be worn. Busch service will only accept vacuum pumps that come with a com- The vacuum pump must be decontaminated prior to disposal. pletely filled in and legally binding signed “Declaration of Contamina- tion”... -
Page 14: Troubleshooting
Risk of explosion in case of operation of faulty equipment! A faulty vacuum pump must immediately be removed from service. In case of faults the cause of which cannot be determined the Busch service must be contacted. WARNING Risk of electrical shock, risk of damage to equipment. - Page 15 Flame arrestors must only be ser- partially clogged viced by personnel that have received specific training for this purpose either by Busch or by the manufacturer of the flame arrestors. Clean the flame arrestor (k) on the pres- sure/discharge side...
- Page 16 Busch service only) The vacuum pump is blocked Solid foreign matter has entered the vacuum...
- Page 17 Therefore the cou- pling element must be replaced by Busch service only) Stuck vanes (i) Repair the vacuum pump (Busch service) Use only approved oils (Ú...
- Page 18 Oil dropping down from the exhaust filter is returned to the oil circula- tion. The oil return line is clogged or broken Repair the oil tubing (Busch service) The oil is black Oil change intervals are too long Flush the vacuum pump...
-
Page 19: Spare Parts
0-9-414 7782 Fax: 0-9-414 7783 Find the list of Busch companies all over the world (by the time of the publication of these installation and operating instructions) on Ú page 24 (rear cover page). Find the up-to-date list of Busch companies and agencies all over the world on the internet at www.buschvacuum.com. -
Page 20: Oil
Denomination VM 100 VE 101 VSL 100 ISO-VG Base Mineral oil Diester Density [g/cm³] 0.888 0.96 0.84 Ambient temperature range 12 ... 30 0 ... 40 0 ... 40 [°C] Kinematic viscosity at 40 °C [mm²/s] Kinematic viscosity at 100 °C 11.5 [mm²/s] Flashpoint [°C]... - Page 21 blank page RE 0016 B / RE 0040 B / RE 0063 B with safety valve, without motor page 21 0870142823...
- Page 22 blank page RE 0016 B / RE 0040 B / RE 0063 B with safety valve, without motor page 22 0870142823...
- Page 23 blank page RE 0016 B / RE 0040 B / RE 0063 B with safety valve, without motor page 23 0870142823...
-
Page 24: Busch - All Over The World In Industry
Busch Vacuum Solutions We shape vacuum for you. Argentina Denmark Malaysia South Africa info@busch.com.ar info@busch.dk busch@busch.com.my info@busch.co.za Australia Finland Mexico Spain sales@busch.com.au info@busch.fi info@busch.com.mx contacto@buschiberica.es Austria France Netherlands Sweden busch@busch.at busch@busch.fr info@busch.nl info@busch.se Bangladesh Germany New Zealand Switzerland sales@busch.com.bd info@busch.de sales@busch.co.nz...