Table of Contents
Advertisement
Note:
•
When the switcher outputs the Guide Screen, the OSD will be displayed continuously until the
countdown timer reaches zero.
•
When the device outputs video input sources, the OSD will be displayed for 10 seconds and
then will disappear.
By default, the access code is set as blank, and therefore the OSD doesn't display the access
•
code. If you want to set access code, please see BYOD section for more information.
Web GUI
The Web UI designed for the HT-MERCURY allows for basic controls and device settings. This
Web UI can be accessed through a modern browser, e.g., Chrome, Safari, Firefox, IE10+, etc.
To get access the Web UI:
Connect the LAN port of the switcher to a local area network. Ensure there's a DHCP server
1.
in the network so that the device can obtain a valid IP address. (If there is no DHCP server
the video bar will revert to a 169.254.x.x address which you can find on the OSD. Use this
to change the video bar IP to a static IP address and set your own.)
Connect the PC to the same network as the video bar.
2.
Input the video bar's IP address in the browser and press Enter, the following window pops
3.
up. (See
OSD
Hall Technologies
November 2, 2022
section to easily view the IP address)
Page 16 of 31
Advertisement
Table of Contents
