Advertisement
4
e
d
a
f
g
Tightening torque 4.5 N·m (0.45 kgf·m, 3.3 lb·ft)
Tightening torque 9 N·m (0.9 kgf·m, 6.6 lb·ft)
INSTALLING THE INCLUDED PARTS
2
e
1
b
c
d
– 10 –
Check that the rear brake hose 2, shift wire 4,
and speed sensor lead e are routed as shown
in the illustration.
8. Installing the saddle
Pinch the rail of the saddle 1 with the saddle
clamps a and b, and then tighten the seat
post c, bolts d, and nuts e to the specified
torque.
Adjust the seat post c height, and then tighten
the seat pin f to the specified torque.
1
Saddle
TIP
8 Face the mark "▲" g of the saddle clamp a
toward the front, and then install the saddle.
8 Be careful that the dropper seat wire is not too
tensioned or too slack when installing the seat
post c or adjusting its height.
8 Do not overtighten the seat pin f. Otherwise, it
could cause the dropper seat not to operate
smoothly.
1
A
Advertisement
