Table of Contents
Advertisement
19 Cleaning aid "humidClean"
The cleaning aid "humidClean"
for occasionally cleaning the cooking compartment.
The cleaning aid softens dirt by vaporising the soapy
water. It is then easier to remove the dirt.
19.1 Setting the cleaning aid
WARNING ‒ Risk of scalding!
If there is water in the cooking compartment when it is
hot, this may create hot steam.
▶
Never pour water into the cooking compartment
when the cooking compartment is hot.
Note: The oven light does not come on during the
cleaning aid.
Requirement: The cooking compartment must have
cooled down completely.
1.
Remove any accessories from the cooking compart-
ment.
2.
ATTENTION!
Distilled water in the cooking compartment leads to
corrosion.
▶
Do not use distilled water.
Mix 0.4 litres water with a drop of washing-up liquid
and pour into the centre of the cooking compart-
ment floor.
3.
Press "Cleaning".
4.
Press "humidClean".
The duration cannot be changed.
5.
Press
.
a A notification stating that you should carry out the
necessary preparatory work for the cleaning aid ap-
pears on the display.
20 Descaling
To ensure that your appliance continues to operate cor-
rectly, it must be descaled regularly.
How frequently you need to run the descaling pro-
gramme depends on the water hardness and how
many times you have used the steam-assisted opera-
tions. The appliance indicates when only another 5 or
fewer steam-assisted operations are possible. If you do
not carry out descaling, you can no longer set any op-
eration with steam.
Descaling comprises several steps and takes
approximately 70 - 95 minutes:
¡ Descaling (approx. 55 - 70 minutes)
¡ First rinse cycle (approx. 8 - 12 minutes)
¡ Second rinse cycle (approx. 8 - 12 minutes)
Carry out descaling in full.
If descaling is interrupted, you can no longer set any
operation. To ensure that the appliance is ready for op-
eration again, carry out 2 rinse cycles.
is a quick alternative
6.
Confirm the notification.
a The cleaning aid starts and the cooking time counts
down.
a Once the cleaning aid has ended, a signal tone
sounds. A notification appears on the display con-
firming that the operation has finished.
7.
Press
to switch the appliance off.
8.
→ "Cleaning the cooking compartment after using
the cleaning aid", Page 29.
19.2 Cleaning the cooking compartment
after using the cleaning aid
ATTENTION!
The prolonged presence of moisture in the cooking
compartment leads to corrosion.
▶
After using the cleaning assistance, wipe the cook-
ing compartment and allow it to dry completely.
1.
Allow the appliance to cool down.
2.
Wipe out the remaining water in the cooking com-
partment using an absorbent sponge cloth.
3.
Clean the smooth enamel surfaces in the cooking
compartment with a dish cloth or a soft brush. Re-
move stubborn food remnants using a stainless
steel scouring pad.
4.
Remove limescale with a cloth soaked in vinegar,
and wipe this away with clean water.
5.
Dry the cooking compartment with a soft cloth.
6.
To dry the cooking compartment completely, leave
the appliance door open for approx. 1 hour or use
the "Drying" function.
→ "Setting the drying process", Page 30
20.1 Preparing descaling
ATTENTION!
The length of time for which the descaler is left to work
is based on the recommended, liquid descaler. Other
descalers may damage the appliance.
▶
Only use the liquid descaler recommended by us
for the descaling programme.
If descaling solution comes into contact with the control
panel or other delicate surfaces, it will damage them.
▶
Remove descaling solution immediately with water.
1.
Mix the descaling solution:
200 ml liquid descaler
‒
400 ml water
‒
2.
Open the control panel.
3.
Remove the water tank and fill it with descaling solu-
tion.
4.
Once the descaling solution has been poured into
the water tank, slide the tank back in.
5.
Close the control panel.
20.2 Setting the descaling programme
Requirement: → "Preparing descaling", Page 29
1.
Press "Cleaning".
Cleaning aid "humidClean" en
29
Advertisement
Table of Contents
