Agm + 12V Mode; Jump Charge Mode - PowerTech MB3910 Instruction Manual

AGM + 12 MODE (15V 15A):
This mode is mainly suitable for charging 12V lead-acid batteries with a
capacity greater than 18 Ah. It can be used to the maximum charge voltage
15V of the special AGM battery such as calcium battery; however battery
manufacturers may recommend the maximum charge voltage for charging
their batteries. Please check battery specifications.
Press the MODE selection button to select MODE AGM + 12V
After doing so, the corresponding LCD display AGM + 12V lights up.
Then if you do not take any further action, the electronic system will
automatically start the charging process together with the LCD display will
flash at (with a current of) 15A. If the process runs without any problems, the
LCD display will show the battery charging (bars will start flashing) until the
battery is charged. When the battery is fully charged, the battery icon should
be full and will stop flashing. The device now switches automatically into
maintenance charging mode.
JUMP CHARGE MODE (15V 20A):
To operate JumpCharge, the charger must be connected to a 12V battery with
the battery clamp connectors connected. If the battery voltage is between 2.0
V and 15 V, and go to charging mode after user presses the JUMP CHARGE
Button.
Charging Program: Begin 2.6A current charging, 270 seconds, then 20A
charging, 30 seconds. After that go to Stand-by mode.
JumpCharge completes after a five minute charge.
NOTE: Use the mode with care. This mode is for 12V Lead-Acid batteries only.
14
.