Warning Plates On The High-Pressure Stage; Fig. 6: Locations Of Power2 Hp Warning Plates - ABB PT004162 Operation Manual

Operation Manual / Power2 845-M / High-pressure stage
2 Safety / 2.7 Warning plates on the high-pressure stage
2.7

Warning plates on the high-pressure stage

Warning plates are affixed at the following locations:
Fig. 6: Locations of Power2 HP warning plates
If warning plates are not present in the designated locations or not readable, proceed as fol-
lows:
Order new warning plates from Turbo Systems service stations.
u
Remove any warning plates that have become unreadable.
u
Clean and degrease the areas designated for the warning plates.
u
Fit new warning plates and remove protective sheets.
u
Non-insulated high and low-pressure stages
High and low-pressure stages supplied to the enginebuilder without insulation must be
equipped later with warning plates to be attached to the insulation. This is the responsibility
of the enginebuilder.
© Copyright 2022 ABB. All rights reserved. HZTL4069_EN Rev.F March 2022