Periodic Check Of The Pressure Vessels; Fig. 8: Location Of Power2 Hp Rating Plate - ABB PT004162 Operation Manual

Operation Manual / Power2 845-M / High-pressure stage
2 Safety / 2.9 Periodic check of the pressure vessels
n , t normally only apply when running at overload (110 %) during trials on the engine
Mmax Mmax
test bed. These limit values can also be permitted during operation for special applications.
Operation above n
Mmax
Failure to observe the recommended replacement intervals increases the risk of unpredict-
able component failures.
Locations of the rating plates on the high-pressure stage
Fig. 8: Location of Power2 HP rating plate
One rating plate each is attached on the left and the right side of the foot (bearing casing)
and to the air suction branch of the high-pressure stage.
2.9

Periodic check of the pressure vessels

The pressure vessels used by Turbo Systems, such as those for wet or dry cleaning, are so-
called "simple pressure vessels".
¡ The locally applicable legal regulations regarding periodic checks of the pressure vessels
must be observed.
¡
The operating company is responsible for the safe operation of the pressure vessel.
WARNING
Danger due to pressure vessels
The operating company must make sure the pressure vessels are in proper
working condition and monitor them. Necessary repair or maintenance work
must be performed promptly, and the required safety measures must be
taken.
Pressure equipment must not be operated if defects are present.
u
© Copyright 2022 ABB. All rights reserved.
and t is not permitted.
Mmax
HZTL4069_EN Rev.F March 2022