Page 2
Notice: LXE Inc. reserves the right to make improvements or changes in the products described in this manual at any time without notice. While reasonable efforts have been made in the preparation of this document to assure its accuracy, LXE assumes no liability resulting from any errors or omissions in this document, or from the use of the information contained herein.
Battery Care Procedures ...8 The HX1 Multi-Charger ...9 Attach Headset... 10 Adjust Microphone and Secure Cable ...11 Belt Carrying Case ... 12 Powering On the HX1 ... 14 Suspend /Resume Button...14 Power LED ...14 Resetting the HX1...15 Entering Data... 16 Getting Help...
Page 4
Figure 3 HX1 Connectors ...5 Figure 4 The HX1 Battery ...6 Figure 5 Inserting the Battery Pack...6 Figure 6 Snap the Battery Pack into the HX1 ...7 Figure 7 Removing the Battery Pack ...7 Figure 8 The HX1 Multi-Charger ...9 Figure 9 Lower Audio Cable ...10...
PCMCIA radio (spread spectrum 2.4GHz) to a voice server. The HX1 is designed for heads up, hands free operation. The HX1 includes a headset. The headset’s speaker relays voice instructions to the user and the user speaks the responses into the headset’s microphone.
Note: Caution WARNING DANGER HX1 User’s Guide All caps are used to represent disk directories, file names, and application names. Rather than use the phrase "choose the Save command from the File menu", this manual uses the convention "choose File|Save".
Water, Sand Dust Operating Humidity E-EQ-HX1OGWW-A Specification -13°F to 158°F (-25°C to 70°C) [non-condensing] -40°F to 185°F (-40°C to 85°C) [non-condensing] IP 64 per IEC529, section 13.4 and 12.4 5 to 95% non-condensing +/-4 kV contact, +/-8 kV air HX1 User’s Guide...
Use this guide as you would any other source book -- reading portions to learn about the HX1, and then referring to it when you need more information about a particular subject. This guide takes you through installation and operation of the LXE HX1.
Install Battery The battery snaps into place on the HX1. Press the battery into place until a small click is heard as the battery lip is captured by the latch. HX1 User’s Guide...
The battery snaps into place when it is properly seated. It may be necessary to press on the end of the battery to make sure it snaps into place. To remove the battery, press the release button and lift the battery from the HX1. E-EQ-HX1OGWW-A...
System Administrator for setup instructions. Battery Care Procedures When the HX1 is not in use, do not allow the battery to discharge. Units should be stored with a fully charged battery. Once a fresh battery is installed, place the HX1 in Suspend mode before placing it in storage.
Charge an HX1 Battery Pack in less than 3 hours. • Recalibrate an HX1 Battery Pack (c1 cycle) an HX1 Battery Pack in about 8 hours • Perform a Learn Cycle (c2 cycle) on an HX1 Battery Pack in about 16 hours.
HX1. Align the 25 pin RS-232 end of the adapter cable with the 25 pin RS-232 port on the HX1. Seat the connector firmly over the pins and turn the thumbscrews in a clockwise direction. Do not over tighten.
Tuck the cable under the belt, but leave a small loop where it goes under the belt. • Do not wear the cable on the front of your body. It may get in your way or get caught on protruding objects. E-EQ-HX1OGWW-A HX1 User’s Guide...
The larger zippered compartment houses the body of the HX1. Extra room is provided for cable connectors on the end of the HX1 and a slot is provided on the end of the case to allow the cables to exit the case. Elastic straps are provided to hold the antenna in place.
4. Close the compartments. A zipper is provided for each compartment to secure the HX1. 5. When the HX1 is installed in the belt carrying case, the battery can be accessed by unzipping only the small compartment. 6. Adjust the straps to fit the user’s waist.
System Administrator for setup assistance. Suspend /Resume Button The Suspend /Resume button can be used to suspend or resume the HX1. It can also be used to reset the HX1. •...
Powering On the HX1 • install. • No lights – Indicates the HX1 is either in Suspend mode or has no battery power. • Alternate Resetting the HX1 Consult your System Administrator before resetting the HX1. It may be necessary for the System Administrator to assist you with setup after resetting the HX1.
Entering Data All data is entered into the HX1 by speaking into the headset’s microphone when prompted. The HX1 transmits data the voice data to the server automatically. Please contact your System Administrator if assistance is needed with the voice software installed on your HX1.
Manuals and Accessories Accessories The table below lists the available HX1 accessories. • Where two parts numbers are listed for a given part, the part number ending in “-R” is the RoHS compliant version. • When only one part number is listed, the part is RoHS compliant unless otherwise noted.
Page 22
Cables, Configuration and Training Devices HX1A051AUDIOCBL Cable, Lower Audio (HX1 to Headset), Requires headset HX1A052CONFIGCBL Cable, Configuration HX1A053YCABLE Cable, Splitter for Walkie Talkie, Mono HX1A054YMICCABLE Cable, Splitter for Walkie Talkie w/Microphone HX1 User’s Guide Manuals and Accessories E-EQ-HX1OGWW-A...
Page 23
Single ear, single headband headset with noise canceling microphone and 5 replacement windscreens HX1A502DUALBHEADSET Single ear, dual headband headset with noise cancelling microphone and 5 replacement windscreens HX1A503BTHHEADSET Dual ear, behind the head headset with noise canceling microphone and 5 replacement windscreens E-EQ-HX1OGWW-A HX1 User’s Guide...
Page 24
Replacement windscreen for all headset microphones, 50 pack HX1A510FOAMEAR10 Replacement foam ear piece cover for single and dual band headsets, 10 pack HX1A511FOAMEAR50 Replacement foam ear piece cover for single and dual band headsets, 50 pack HX1 User’s Guide Manuals and Accessories E-EQ-HX1OGWW-A...
Absorption Rate (SAR) limits. Highest reported SAR for HX1 is .228W/kg on body. Any accessories not provided by LXE should not be used with this device. This device must not be co- located or operating in conjunction with any other antenna or transmitter.
A label on the exterior of the device should resemble one of the labels shown below (the label contains the LXE part number of the installed radio card). The labels shown below and affixed to the device, identify where the device may be used and where its use is restricted. Use of a device is prohibited in countries not listed below or otherwise identified by the label.
EN 300 328-1 and -2: 2000-7 Safety: EN 60950-1: 2001 We, LXE Inc., declare that the equipment specified above complies with all Essential Health and Safety Requirements of the above Directives and Standards, as amended Place: LXE Inc., Norcross, GA USA Date of issue: 23 October, 2006 LXE Inc.
Page 28
EN 300 328, and therefore meet the definition of ‘dedicated antenna’ per ERC/REC 70-03 Appendix 1 Table 3; thus the requirement set forth in ERC/REC 70-03 , Annex 3 are met by the LXE model 4830 transciever. Dedicated Antennas for use with LXE 4830...
EN 300 328-1 and -2: 2000-7 Safety: EN 60950-2: 1992 + A1..A4 We, LXE Inc., declare that the equipment specified above complies with all Essential Health and Safety Requirements of the above Directives and Standards, as amended. Place Date of issue LXE Inc.
Page 30
The LXE 6726 can be equipped with external antennas. The antennas listed have been evaluated with the LXE 6726 pursuant to ETSI EN 300 328, and therefore meet the definition of ‘dedicated antenna’ per ERC/REC 70-03 Appendix 1 Table 3; thus the requirement set forth in ERC/REC 70-03 , Annex 3 are met by the LXE model 6726 transceiver.
Pila de litio adentro. Peligro de explosión si la pila se reemplaza incorrectamente. Reemplace solamente con el mismo tipo o equivalente recomendado por el fabricante. (ES) Oppassen: Bevat Lithium-batterij. Incorrrecte plaatsing van batterij kan leiden tot explosiegevaar. Alleen vervangen door hetzelfde of door fabrikant aanbevolen gelijkwaardig type. (NL) E-EQ-HX1OGWW-A HX1 User’s Guide...
Page 32
Lithium Battery Safety Statement (GR) (JP) Dikkat: (TR) Legend: Chinese Danish Dutch English Finnish French German Greek HX1 User’s Guide (KR) (CN) Italian Japanese Korean Norwegian Portuguese Spanish Swedish Turkish Regulatory Notices E-EQ-HX1OGWW-A...
Voxware Software does not mean that such portion has been published and will not derogate any claim of trade secret protection for the same. Title to all complete or partial copies, together with all applicable E-EQ-HX1OGWW-A HX1 User’s Guide...
Page 34
"need to know”. Such employees of the End User are to be advised by the End User of the confidential and proprietary nature of the Voxware Software, Documentation, and all materials and information related thereto, and agree to be bound by such restrictions. HX1 User’s Guide End User License Agreements E-EQ-HX1OGWW-A...
Page 35
United States, and all necessary approvals (both United States and foreign government approval) have been duly obtained. E-EQ-HX1OGWW-A HX1 User’s Guide...
Page 36
Whereof, Voxware and End User have executed this EULA by their duly authorized representatives as of the Effective Date. Effective Date End User Type Signature Name Title Address City State/Prov. Zip/Postal Country HX1 User’s Guide End User License Agreements Voxware Voxware, Inc. Type Delaware corporation Signature Name Title Address 168 Franklin Corner Road, Building 1, Suite 3...
Licensee to a third party, such Licensed Software may be assigned or transferred upon the assignment or transfer of such Equipment if, and only if, the third party agrees in writing acceptable to LXE to assume and comply with any and all of the terms and conditions of this License.
Page 38
LXE’s right to obtain injunctive relief shall not limit its right to seek further remedies under Section 3, any other provisions of this License, or otherwise.
Need help?
Do you have a question about the HX1 and is the answer not in the manual?
Questions and answers