Adjusting The Illuminant; Fuse Replacement; Disposal; Technical Data - Conrad Electronic Bravo Scan 250 Operating Instructions Manual

Adjusting the illuminant

You position the illuminant with the screws A, B and C on the installation plate on the rear at the connection field of
the light effect:
• Project a fixed circle.
• Set the screws A, B and C in such a way that the circle is evenly lit.

Fuse replacement

If you have to replace fuses, ensure that you only use fuses of the same type and rated current (see „Technical data").
It is absolutely impermissible to repair fuses or to bridge the fuse holder.
• Pull the mains plug out of the outlet and separate the non-heating appliance plug from the mains connection on
the device.
• Carefully prise the fuse holder with a screwdriver out of the mains connection.
• Remove the defective fuse and replace it with a fuse of the same type.
• Carefully push the fuse holder with the new fuse back into its holder at the mains connection.
• Only then may you reconnect the device to the mains and put it into operation again.

Disposal


Please dispose of the device when it is no longer of use, according to the current statutory requirements.

Technical data

Operating voltage .............................................................. 230V AC/50 Hz
Power consumption ........................................................... 340W
Illuminant ............................................................................ NSK250/2
Fuse .................................................................................... F4A/250V (5x20mm)
DMX protocol ..................................................................... DMX512
DMX channels .................................................................... 8
Dimensions ........................................................................ 580 x 268 x 213mm
Weight ................................................................................ 11.5kg
Item no.: 58 91 79
33