Safety Instructions - Conrad Electronic Bravo Scan 250 Operating Instructions Manual

Safety instructions

The guarantee/warranty will be void if damage is incurred resulting from non-compliance with
the operating instructions. Liability for any and all consequential damage is excluded!
Nor do we assume liability for damage to property or personal injury, caused by improper use
or failure to observe the safety instructions. In such cases the guarantee/warranty will be void.
Dear customer, The following safety instructions and risk information do not serve for protection of the
device but for protection of your health. Please read carefully through the following points:
• For safety and licensing (CE) reasons, unauthorised conversion and/or modifications to the product
are not permitted.
• The device is constructed according to protection class 1. As a voltage source only a proper power
socket (230V~/50Hz) of the public power supply system with earthing contact may be used.
• All persons operating, installing, setting up, commissioning or servicing this effect beamer must be
trained and qualified correspondingly and observe these operating instructions.
• Do not look straight into the light source during operation. Temporarily, the light flashes can lead to
visual defects. They can furthermore possibly cause epileptic fits. This applies particularly to
epileptics.
• Never touch the mains plug when your hands are wet or damp. There is a risk of a fatal electric shock.
• If the cables show damages, do not touch them. First of all, de-energize the corresponding mains
socket (e.g. via the respective circuit-breaker) and afterwards carefully pull the mains plug from the
socket. Separate the mains cable from the device and replace it. Never use the product if the power
line is damaged.
• When installing the device, make sure that the mains cable is not pinched or damaged by sharp
edges.
• The product is not a toy and should be kept out of reach of children! Children cannot judge the
dangers involved when handling electrical devices.
• Never position vessels or containers containing liquids, such as glasses, buckets, vases or plants,
in the direct vicinity of the system. Liquids could seep into the casing and in doing so impair the
electrical safety of the device. There is furthermore a high risk of fire or of a life-threatening electric
shock. If this is the case, de-energize the respective socket (e.g. switch off circuit breaker) and only
then pull the plug-in mains unit from the socket. Afterwards, the product must no longer be used; take
it to a specialist workshop.
21