Setting The Operating Mode; Demo Operation; Sound-To-Light Control; Slave Mode - Conrad Electronic Bravo Scan 250 Operating Instructions Manual

Setting the operating mode

The DMX scanner can be controlled with the installed controller (music control via microphone or demo operation)
or with an external DMX controller. In addition, it can also be controlled as slave device via the controller of another
light effect.
The operating mode is set via a display (4) and the buttons (5) MODE, UP and DOWN.
With the MODE button, you select the operating mode and with the buttons UP and DOWN the options.

The unlabeled button is without function.

Demo operation

• Press the button MODE until the display shows „RUN".
• Select the menu point „PrG1" with the buttons UP and DOWN.
• Now the DMX scanner runs in demo mode, meaning the sequences saved in the installed controller run.

Sound-to-light control

• Press the button MODE until the display shows „RUN".
• Select the menu point „PrG0" with the buttons UP and DOWN.
• The DMX scanner now runs in sound-to-light mode; the light effects are controlled at the beat of the music via
the installed microphone.

Deactivating the installed controller

• Press the button MODE until the display shows „RUN".
• Select the menu point „OFF" with the buttons UP and DOWN.

If you want to operate the DMX scanner in a different mode than demo mode or in sound-to-light mode,
you previously have to deactivate the installed controller.

Slave mode


The installed controller must be deactivated for this type of operation (see „Deactivating the installed
controller").
• Press the button MODE until the display shows „RUN".
• Select the menu point „FOLL" with the buttons UP and DOWN.
• The DMX scanner now runs in slave mode, the light effects are controlled via the controller of another light effect,
which is connected to the DMX input.
27