Reversing The Direction Of Movement; Reset; Dmx Control - Conrad Electronic Bravo Scan 250 Operating Instructions Manual

Reversing the direction of movement

You can reverse the rotation and swivel mode of the DMX scanner.
• Press the button MODE until the display shows „PAN" or „TILT" (for both motion directions).
• With the buttons UP and DOWN, select the menu point „YES" or „NO" to reverse the direction of the respective
motion mode.

Reset

You can reset the control of the DMX scanner to the default settings without separating the power supply. This is e.g.
required if the control no longer reacts.
• Press the button MODE until the display shows „rESt".
• Press the button UP or DOWN to perform the reset.
• Then set the desired operating mode again.

DMX control


The installed controller must be deactivated for this type of operation (see „Deactivating the installed
controller").
Each DMX device in a DMX chain requires a so-called start address to be clearly identified by the controller.
This start address is also set in the menu.
• Press the button MODE until the display shows „Addr".
• Select the desired DMX start address with the buttons UP and DOWN.
• Save the setting by pressing MODE again.
• Now the DMX scanner is operated via the connected DMX controller. It requires 8 DMX channels.
28