Wiring Instructions For Inter-Unit Connections - Sanyo C2432A Installation Instructions Manual

3-20. Wiring Instructions for Inter-Unit Connections

(1) Insert the inter-unit wiring (according to local
codes)into the through-the-wall PVC pipe. Run
the wiring toward the indoor side allowing approx.
10 inch toextend from the wall face. (Fig. 65)
(2) Route the inter-unit wiring from the back of the
indoor unit and pull it toward the front for
connection.(Fig. 66, 67)
(3) Connect the inter-unit wiring to the corresponding
terminals on the terminal plate (Fig. 66, 67) while
referring to the wiring diagram.
(4) Be sure to secure the wiring with the provided
clamp.
How to remove the cover plate
To access the terminal plate inside the indoor unit,
follow these steps.
(1) Using a Phillips screwdriver, take out the screw
on the cover plate. (Fig. 66, 67)
(2) Remove the cover plate.
KS2432A
Rear
panel
Wiring
10 in.
Fig. 3-65
Cover plate
Fig. 3-66
Earth
plate
Top of conduit
connector
Fig. 3-67
28
S4359249
Wall
Plastic
cover
2246_T_I
Terminal
plate
2247_T_I
Inter-unit
control line
wiring
Lock nut
2248_T_I