Sanyo C2432A Installation Instructions Manual page 29

Wiring Instructions for Inter-Unit Connections
(a) Insert the inter-unit wiring (according to local
codes) into the through-the-wall PVC pipe. Run
the wiring toward the indoor side allowing approx.
5". to extend from the wall face. (Fig. 3-68)
Never fix the wiring by any
means before the indoor
CAUTION
unit is fully seated on the
rear panel.
(b) Remove the side cover and the metallic cover.
(Fig. 3-69 or 3-70, depending on model.)
(c) Secure the conduit connector to the chassis with
a lock nut. (Fig. 3-69 or 3-70)
(d) Give some play to the inter-unit wiring from the
outdoor unit to the corresponding terminals on the
terminal plate.
Be sure to refer to the
wiring system diagram
CAUTION
label inside the metallic
cover and carry out the
correct field wiring.
Wrong wiring can cause
the unit to malfunction.
Check local electrical
codes and any specified
wiring instructions or
limitations.
(e) Secure the metallic cover with its screw. Then
replace the side cover.
KS2432
Lock
nut
Power line
Grounding
line
Look nut
Elbow
conduit
Fig. 3-69
KS2432
KS3032, KS3632
KS3032, KS3632
Metallic cover
Plastic cover
Screw
Lock
nut
Connector
0968_T_I
29
S4359249
Rear
panel
Plastic
cover
Wiring
5"
Wall fixture
Connector Wiring
5"
Fig. 3-68
Metallic cover
Fig. 3-70
Wall
1362_T_I
Wall
1363_T_I
Side cover
1364_T_I