Advertisement
STEPS
1. Unscrew the tail from
the body.
3. Place the rest of the
drain into the sink from
the top. Make sure the
drain overflow port is
aligned with the sink's
overflow cavity cut-out.
If the cap has a
Watermark logo on it
then make sure to align
it to the desired
orientation.
5. Apply Teflon tape to the thread on the tail and
screw the tail back into the body.
•
USE TEFLON TAPE OR PIPE SEALANT FOR THREADED CONNECTIONS
•
DO NOT USE PLUMBER'S PUTTY ON ANY OF THE BRASS COMPONENTS
This will cause the finish to tarnish. A non-corrosive Alkoxy Silicone is recommended.
•
DRAINS ARE ONLY UNDER WARRANTY FOR MECHANICAL FAILURE, NOT FOR FINISH DEFECTS
350 Dewitt Avenue, Brooklyn, NY 11207 USA T 718.257.2800 F 718.257.2144
IMPORTANT INSTALLATION INFORMATION
For technical support, please call 718-257-2800
MPU5 Soft Touch Lavatory Drain with Overflow
2. Unscrew the nut
and remove the
washer and the
bottom gasket
from the body.
4. Place the
bottom gasket on
top of the nylon
washer, then place
the nylon washer
on top of the nut,
finally screw the
nut back onto the
body. Do not over
tighten the nut.
6. Connect the drain to the trap and check for
leaks.
www.watermark-designs.com
Page 2
Advertisement
