Bajaj pulsar F250 2022 Service Station Manual page 48

SKILL TIPS / NOTES AT PDI STAGE
Battery –ve terminal fitment. (For more details, Refer Battery replacement SOP)
Bracket latch seat removal
Mirror fitment for Pulsar F250 during PDI :
• Apply limaplex(HTX 3) grease(Refer spare parts catalogue for part number) as
shown in photograph before mirror fitment on vehicle.
For Mirror fitment SOP, refer "Headlamp / Speedometer / Harness speedometer /
Flap speedometer / Structure speedometer / Windshield / Fairing structure
Replacement" SOP given in electrical section of Pulsar F250 Service station manual available on E-SSM
Leg Guard fitment during PDI
Washer to be fitted on LH Leg guard bottom mounting only.
Sequence seen from outer side:
Nut Leg guard
Importance of washer :
To avoid leg guard fitment on vehicle in stressed condition, this washer is to
be fitted.
Torque value
Leg guard mounting Top bolt : 2 – 2.2 Kgf-m
Leg guard mounting bottom nut : 2 – 2.2 Kgf-m
Clutch cable routing while Leg guard Fitment
Route the clutch cable as shown in photograph. Clutch is to be routed
above leg guard.
Service Station Manual
Nut fitment direction
Washer
Battery terminal fitment
42
Leg
guard
Washer-KDAB0816
to be fitted
on LH Bottom
mounting
Service Support - M/C
Nut