Bajaj pulsar F250 2022 Service Station Manual page 36

CONTROL SWITCHES / IGNITION SWITCH / HEADLIGHT /SIDE STAND INFORMATION
Condition 2 : Ignition ON, Kill switch ON,
Headlight Switch
Position
Low beam
High beam
Headlight
LED Headlamp Condensation:
Condensation inside headlamp is a natural phenomenon. Condensation occurs when atmospheric air containing
water vapor or humidity enters the headlamp through the vents due to temperature difference. A thin film of fog can
form on the inside surface of the headlamp lens. The thin fog will clear and exit through the vents during normal
operating condition. Condensation & fogging of headlamp lens may happen during rain or after washing. Moisture
condensation inside the headlamp lens will disappear gradually by switching ON the headlamp in high beam and
driving the vehicle at 30 to 40 Kmph speed for about 15 minutes. Time for evaporation will vary depending on the
humidity of the ambient air.
Side Stand
Side stand condition
Down
Down
Steering cum Ignition switch
Service Station Manual
Engine ON
Headlight
Low beam
High beam
Side stand Indication in speedometer
Yes
Yes
Yes
Effect on pressing
Position Lamp
ON
ON
Gear position
Neutral
Gear is applied in vehicle
start condition by pressing
clutch lever
Gear
30
Pass switch
High beam
High beam,
No change
Remark
Vehicle gets started after
pressing self start button
Vehicle gets OFF
Self starter is disabled,
vehicle will not start
Service Support - M/C